Заметки сисадмина о интересных вещах из мира IT, инструкции и рецензии. Настраиваем Компьютеры/Сервера/1С/SIP-телефонию в Москве

HP V1810 Switch Series – How to Reset the Switch to Factory Defaults

2015-01-22 · Posted in Сеть
  1. On the front panel of the switch, there is a Reset and a Clear button.

  2. Press and hold both buttons for a few seconds, then release the Reset button while continuing to hold theClear button.

  3. Watch the LED Mode lights on the left side of the switch (Act, FDx, and Spd). 4. Once the LEDs flash twice, release the Clear button and allow the switch to finish booting.

This should reset the switch back to factory defaults. The switch will now have a factory default IP address of 192.168.2.10.

Leave a Reply